Why does the spinning wheel explode when throwing thread?

1, which is related to the thread thickness and material. If the thread is thick and hard, it is easier to explode and knot; The main line should be selected with moderate toughness and hardness. At present, PE wire is generally used in Luya line, and carbon wire can be used as lead wire, which is not suitable for main line.

2. It is related to the degree of thread tightening. Too loose, needless to say, will of course cause knots; It's too tight to get out easily. When throwing, the speed of the line will be uneven, and the back will be knotted if it exceeds the front.

3. Throwing poles against the wind can easily lead to wire explosion. This is because the wire will be blown back by the wind after being thrown, and the wire in the wire cup will continue to be released, so some wires will be twisted and clamped by the wind, resulting in wire explosion.

4. The thread in the threaded cup is too full. If the thread in the threaded cup is too full, the loose thread on the surface will be led out when throwing the rod, and then it is easy to make fried thread. The best thread capacity of threaded cup should be 8 ~ 90%. Don't let too much thread into the threaded cup, so that the threaded cup is too full.

Extended data

Precautions for use:

1, and when the hook in the fish escapes at high speed, it must not be tightened instantly to release its strength. Instead, you should press the wheel cup with your fingers and apply a little pressure to relieve the impulse of the fish.

2. The handbrake wheel exerts pressure on the wheel cup through the brake lever, which is characterized by instantaneous stop and instantaneous release of force.

3. It is suitable for catching target fish with many underwater obstacles and the habit of digging holes. Mostly used for rock fishing.

4. Because of its low tolerance, it is not suitable for beginners.

5. It is also not suitable for fishing in other fresh water bodies.

6. Most of the high-end spinning wheels are developed and designed by Luya Sports, and the close parallel winding technology is applied. So that the winding can be well installed in the bobbin under the condition of no load. The problems of disorderly wiring and loose flat cable are greatly avoided.

7. When using the spinning wheel, special attention should be paid to avoid scratching and wearing the edge of the front silk cup. Don't put it on the concrete floor at will. Once this position is rough, it will greatly affect the fluency of throwing.

maintenance instruction

1. The internal structure of the spinning wheel is very complicated. If it is not necessary, it is best not to disassemble it at will.

2. After fishing at ordinary times, if the wheel body is dirty, rinse it with clear water and drop some protective oil on the bearing and other parts.

Baidu Encyclopedia-Lu Yalun