What is the appropriate distance between toilet pits?
1. When you haven't finished the decoration, confirm the pit spacing of the bathroom with the decoration master in advance, and the installation master will consider the thickness of wall tiles and cement according to your needs; If you have finished decorating, just take a tape measure. Remember to keep the tape level with the ground, and then start measuring from the center of the pipe. Some small bosses don't say anything, just break the tape measure, go straight to the pipe, and then buy the toilet immediately. Finally, the toilet cannot be installed because of the wrong pit distance measurement.
2. In another case, the toilet at home is very old and I want to change it to a new one, but because the old toilet has not been removed, it is impossible to measure the specific toilet pit distance. At this time, you can look at the residents downstairs. Many houses have the same specifications and sizes. You can ask. Or a little more troublesome, your toilet is a siphon toilet, which is measured directly from the drain in the toilet. When buying a new toilet, its size should not exceed the size of the original toilet.
3. The toilet pit distance serves the toilet. When the toilet pit spacing is special, such as the pit spacing is too large or too small, when the pit spacing is too large, the gap from the wall can be filled to form a simple storage platform; When the pit spacing is too small, the toilet displacer can be used to seamlessly connect the ground sewage outlet with the toilet sewage outlet through special pipes, or a certain thickness can be gently cut on the wall to meet the needs of the pit spacing in the bathroom.
How to choose the toilet pit distance
1, when measuring the distance of the toilet pit, you can clean the sewer pipe first, and then check to make sure there are no sundries before measuring. You can drill a hole with a diameter of 20mm and a depth of 60mm at the mark, insert a bolt with a diameter of 10mm into the hole, remove the toilet after the test, then align the four bolt holes with the bolts, align them evenly, cover the rubber pad with the bolts, and screw on the nuts.
2. When measuring the pit distance of the toilet, you can draw a horizontal line 800mm above the ground in the middle of the toilet, and make a hole with a diameter of 30mm and a depth of 70mm at the cathode. Then insert a bolt with a diameter of 10mm and a length of 100mm into the hole, tighten the cement, hang it on the bolt beside the water tank, level it, align it with the center of the toilet, put a rubber pad on it, and screw on the nut until it is moderately elastic.
3. When installing the water elbow of the water tank, you can remove the nuts of the water outlet and the toilet mouth, insert the upper end into the water outlet of the rear water tank and the lower end into the water inlet of the toilet, then push the rubber pad to the water outlet and screw on the nuts. Insert the asbestos rope or lead oil twine at both ends of copper pipe or plastic pipe into the entrance and exit of drift door and splayed door respectively, and tighten the nuts.
Everyone knows the importance of toilets, and it is very important to choose the pit spacing when choosing toilets. The above is how the spacing of toilet pits is appropriate and how to choose the spacing of toilet pits for everyone.