How to install the toilet
Check the ground drain pipe, install the toilet outlet pipe, and install the water tank elbow at the mark. First, check the ground drain to see if there is any garbage accumulation inside. If so, be sure to check it carefully and clean it up. If it is not cleaned properly, it is likely to cause problems such as toilet blockage.
1. Try to install the outlet pipe of the toilet, mark the bolt hole of the toilet with a marker, and then remove the toilet.
2. Open a hole with a height of 6cm at the mark of 1.5-2 cm, and then screw the bolt of 1cm into the hole with cement. Then put the toilet on it to see if it matches, and remove the toilet after inspection. Then apply putty around the toilet outlet pipe and sewer pipe buckle, and then align the bolt holes with the twisted bolts and straighten them.
3. Make a hole with a diameter of 3cm and a height of 7cm according to the position of the two holes on the back of the water tank, and then screw the bolt with a diameter of 1cm and a length of 10cm into the hole with cement. Then hang the water tank on the bolt, straighten it and tighten it. Remember to pad the bolts with leather pads.
4. After the above steps are installed in place, we need to install the water tank launching elbow, remove the nuts of the water outlet of the rear water tank and the water inlet of the toilet, install them on the upper part of the launching elbow back to back, and then put on the rubber pad. Then install the upper end of the sewer elbow with the sewer outlet of the rear water tank, insert the lower end into the toilet inlet, and tighten the nut.
6. Measure the diameter of the water tank and the size of the water pipe mouth, match other parts, then put the splayed door into the water pipe, and then put the diameter door and splayed door nut back on the copper pipe. Finally, lead oil rope is wound on both ends of the pipe, and then the diameter and splayed door are inserted, and the nuts are tightened.
What are the precautions for installing the toilet?
1. Do not place it in direct sunlight, near direct heat source or in contact with oil fume, otherwise it will cause discoloration.
2. Do not place hard objects and heavy objects, such as water tank covers, flower pots, buckets and basins. Otherwise, it will scratch the surface or cause cracks.
3. The cover plate and seat ring should be cleaned with a soft cloth. Strong acid, strong carbon and detergent powder are prohibited from cleaning. Do not use volatiles, thinners or other chemicals for cleaning, otherwise it will corrode the surface. Do not use wire brushes, blades and other sharp objects for cleaning.
4. When the cover plate is installed in a non-water tank or a low-water tank, people can't lean back, otherwise it will break.
5. The cover plate should be lightly opened and closed to avoid direct collision with the water tank, leaving spots and affecting the appearance; Or it may lead to a fracture.
6, the use of metal hinges (metal screws) products should be paid attention to, do not let acid and alkali solvents adhere to the product, otherwise it is easy to rust.
7, in order to ensure the correct construction and installation of the bathroom, please try to apply glass glue seal.
8, don't rush into the toilet newsprint, paper mats, sanitary napkins and other easily blocked items.
9. Debris that accidentally falls into the toilet should be removed in time. When blocked, it should be removed immediately by skin suction.
10, don't touch hard utensils or rough fabrics, and don't knock or bump.
1 1, regularly scrub the attached dirt with detergent, and remove it with a brush if it is not clean; Keep its surface clean.
12, which cannot be used and stored in water environment below zero degrees Celsius.
13, every time you flush, tilt the wrench or press the button, the force should not be too great to avoid damaging the water tank fittings.
The above is how to install the toilet. If you are interested in installing the toilet, you can look at the basic installation process and precautions, master the correct installation method, and play a better installation and use effect. In addition, when installing the toilet, we should pay more attention to what needs attention. If you choose some inferior decoration materials or do not master the correct decoration scheme, it will be more likely to be damaged during use and the maintenance will be very troublesome.