The method of tying the main line and sub-line of the fishhook is as follows:
1. Main line
First, pass the main line through one end of the figure-eight ring. Wrap the short end around another fishing line at least 4 times, then pass a shorter section of line through the folded part of the eight-figure ring, and finally tighten the fishing line.
2. Sub-threads
First pass the sub-thread through the figure-eight ring, then use the knotted end to wrap it around the double-gou sub-line several times, and then pass the thread end through the figure-eight ring closest to the figure. Just use the loop at the other end of the loop. Note that the knot position should exceed the position of the loop.
Introduction
There are single hook tying method and double groove tying method for fish hooks. The single hook tying method is similar to the figure-eight ring tying method, that is, fold the fishing line in half 1. Then pass the folded part through the wire loop, wrap the separated wire end several times and then tighten it through the buckle. Finally, cut off the excess wire end. This is usually used when there are many obstacles around the fishing point. Single hook for fishing.
The double-groove binding method is actually a tying method of sub-threads. It does not require knotting, but it will take a long time to replace the sub-threads. The principle is to fold the sub-threads in half and remove the ones without fishhook. Pass one end through the wire loop and finally through the buckle.