First, prepare the hook, fishing line, lead clip and bait.
Second, put the fishing line through the eye hole at the top of the hook.
Third, put the fishing line in a splayed knot. That is, the end of the line is wound in a figure of eight.
Fourth, tighten, that is, pull the end of the line away and tighten the eight characters.
Fifth, put the lead clip, and pass the end of the wire through the central hole of the lead clip, usually tying a knot between 20 and 30 meters. The length can also be determined as required.
6. Hang the bait on the hook and the hook will be knotted.
The method of reversing the hook is: first, pass the fishing line through the hole at the top of the hook, and then tie the fishing line into a figure-eight knot, and the end of the line should be wound into a figure-eight. Tighten it after winding, and the extra thread ends need to be cut off with scissors. Be careful not to cut too close, and it is best to leave about one centimeter. Then clamp the conductor, pass the tail through the small hole in the center of the conductor and tie the knot at a distance of 20~30 meters. Finally, the bait is directly hung on the hook, thus completing the binding of the hook.
In fact, this binding method is relatively simple, but when binding, it should be firm and fixed firmly to prevent the phenomenon of falling off. This method of inverted fishing is more suitable for catching some deep-water fish, because it allows the angler to control the barb and whether the specific position in the water is deep or shallow.