One,
Materials for making fishing line groups on the platform: 1, main line 2, secondary line 3, space bean 4, floating seat 5, lead seat 6, hook 7 and 8-shaped rings (secondary clips).
Second, the production method: there are top-down and bottom-up two kinds. I usually use the order from top to bottom, that is, tie two knots at the thread first, and then connect the rod slightly.
Pay-off until it exceeds the rod length 10 cm. Then put on two space beans-floating base-three space beans-lead base-1space bean-and tie the 8-character ring in turn. (In my previous post, the pictures of the cable group, hook and eight-character ring tie method are similar to my other thread tie post, so I won't reprint the pictures here for the time being. In addition, I suggest using four of the three kinds of space beans on the leading base competitors. )
It should be noted that when tying knots and wearing space beans, it is best to soak the thread in water first to prevent friction from damaging the thread.
If it is used for fishing, a space bean should be added above and below the lead seat to prevent displacement (rubber lead seats without space beans can also be used instead).
This produces a straight line, which is generally best used.
It is also very important to make the sub-wire, in order to keep the strength and length of the sub-wire consistent to the maximum extent (it is not necessary to adjust the drift again after changing the hook).
To tie the sub-line, first prepare the appropriate sub-line (the one marked へらハリス) and fish hook according to the characteristics of the target fish, and several small tools (a board for determining the length of the sub-line, a small fork for knotting, a ruler for fixing the hook distance or a hook for fixing the hook distance).