Details that should be paid attention to in construction:
First, how to deal with small bubbles when pasting wallpaper: Although most wallpaper is easy to paste, it is not easy to produce bubbles. However, if you have no experience in wallpaper pasting, small bubbles will inevitably appear. The solution is to puncture the hole with a fine needle to remove air, and then flatten it.
Second, the wall should be coated with a layer of mucilage before the iron arm, which can make the wall smooth and the wallpaper stick more firmly.
Third, when pasting wallpaper, be careful not to let the paste touch the furniture and floor, which is difficult to erase after solidification.
Fourth, how to deal with the sticky paste of wallpaper.
1. Pay attention to the order. First pour a certain amount of cold water into the bucket, then slowly add the required amount of rubber powder and stir well.
2. It is best to use it after 15 minutes.
Five, how to cut wallpaper
1. If you want to see the direction of the pattern clearly when cutting wallpaper, you'd better make a mark.
2. Measure the height between the wall and the skirting board. Different wall heights may be different. Measure a few more places, take the maximum value, and add four inches at both ends for trimming.
3. Spread the wallpaper on a clean table, measure the length and draw a line on the back with a pencil. Then cut it off.
4. Align the cut wallpaper diagonally with the remaining wallpaper and with the pattern. By analogy, cut out a batch of wallpaper and write the serial number on the back.
6. How to apply adhesive before wallpaper?
1. Put the cut wallpaper face down on the table.
2. Brush along the center of the wallpaper, and then brush it into a figure of eight from the center to both sides.
3. Check whether the adhesive is evenly coated, and fold the part coated with adhesive in half, taking care not to fold the crease.
4. Apply adhesive one by one according to the above steps until it is completely coated.
5. Fold the right half of the paper in half, so that the first and second ends just touch together, and recognize which end is the top. When cutting wallpaper, you can note the word "Shang" on the back of the upper end.
6. After the adhesive is coated, it must be left for a period of time to absorb the moisture in the adhesive. Thick wallpaper usually needs to be placed for 10 to 15 minutes.
7. The water absorption time of each wallpaper should be consistent, otherwise the patterns will be difficult to align.
I hope I can help you.