Did you sew the yang angle into a circle?
First, paint the walls with lime and putty; Then, the corner protection net is evenly and forcefully pressed on the wet cement surface, so that the cement sand overflows from the round hole and becomes full, smooth and straight. Pay attention to the alignment of contacts, there can be no convex and concave phenomenon; At this time, the corner protector should be attached to the wall. If it is loose, fix it with nails or caulking paste. At this point, the corner protector is faintly visible; Brush a layer of mortar (putty) to smooth it. After natural air drying, gently polish with sandpaper. Just brush the sewing agent.
Construction skills of external corner of beauty agent?
Type: support layering
Generally, in the process of buying ceramic tiles, merchants will recommend matching layering to owners, especially antique bricks. The layering of this collocation has a round edge, similar to polished bricks.
The second type: 45? Angle collision processing
Two tiles cut diagonally 45? Spell 90 Right angle, baoyang angle, when touching the angle, reserve a gap of 1mm, and the mortar can only be joined after it is completely solidified with strength and no shrinkage, otherwise it will squeeze the thin edge. The corner touching technology is economical and practical, and the color is uniform, so the appearance is beautiful and generous, and the decorative effect is particularly good.
The third type: use corner guards.
The bus line can be used directly without chamfering, and there will be no opening or porcelain collapse due to wall deformation in the future. Moreover, its edges and corners are smooth, and it will not be scratched carelessly, which is also a widely used treatment method at present. But after using for a long time, the outer corner line is easy to yellow and scratch.
The fourth type: tiles are round.
This practice requires high quality tiles. Tiles with insufficient density can't be treated like this, so it needs patience and slow polishing. At the same time, the polished inferior tiles are prone to color difference, which needs to be overcome. However, the polished corners are rounded corners to avoid unintentional collisions and injuries in daily life and enhance the safety of home life.
Fifth: Tile chamfering
It can prevent tiles from bursting due to thermal expansion and contraction, but the aesthetic effect is not good. Moreover, in the process of tiling, tile chamfering is a highly technical process, which takes a lot of time and is not easy to do well. Bad masters often have to polish and trim many times to meet the requirements, and sometimes they accidentally cut off the tiles. Therefore, many inexperienced workers and masters will not choose this way to deal with the outer corners of tiles.
Sixth: caulking agent filling.
First, the tiles need to leave gaps, and then fill them with caulking agent or caulking agent. But on the one hand, the adhesion of this right-angle sealant will not be too good, and it may fall off; Secondly, because the area of the sewing agent is too large, it is difficult to clean it with oil, and it may change color after a long time. Therefore, this method is usually not used in bathrooms and kitchens, and balconies can be considered, but waterproofing must be done well.
The above is the method I introduced to make a circle with a beautiful seam. Construction skills of external corner of beauty agent? We already know. As we all know, the tiles must be sewed beautifully after decoration, because it can reduce the growth of bacteria. Of course, if the outer corner is rounded, it needs some skill. You can find a professional master, so the effect will be better without affecting the overall beauty.