Tools/raw materials
sweater
Methods/steps
1 Prepare a sweater, wrap the sweater rope around it, press the intersection with your index finger and thumb, and put the middle finger and ring finger into the circle.
When you're done, wind the thread to make a smaller circle.
According to the above method, go back and call another one.
After winding three times, just put one end of the rope through the hole in the middle.
Are these two small Chinese knots nice?
Ten tying methods of wool rope:
The first crossed double circle system method
This method is suitable for short sweater belts. The two belts cross and circle, and the belt heads cross and press. Simple and generous.
The second double bow tie method
Stretch out your index finger and middle finger, wrap the rope around twice, pass through the middle, and finally put the rope between the two lines, so that the bow is finished.
The third method of wheat ear system
First of all, we made a big circle, and finally braided it like braids to finish the final finishing, so that a knot of wheat ears was completed.
Fourth single bow tie method
Make a circle first, then thread the rope through it, then tighten it, then make a circle of the same size on the side, then put the rope end in this circle, make another circle, hold one side of the circle, tighten the rope, and then pull out the other rope and adjust it.
The fifth Chinese binding method
First make a circle, then make a circle, and finally make a small circle and put it into the small hole, so that a Chinese knot is completed, which is very beautiful.
The Sixth Sunflower System Method
Sunflower is very cute and suitable for girls. Pick up the rope and wind it seven or eight times. The head passes through the round hole and the circle is tightened. After adjustment, pass through the middle to expose a little thread.
Seventh pipa fastening method
First, a big circle is wound around a string, the left hand holds the upper part, the right hand passes through the string, and then the string is woven from left to right in turn to the end of the string, and the very round lute buckle is completed.
Eighth stereo ear system method
The belt is wound into a small circle and then woven with the head of the belt in a way of crossing up and down. When knitting, pay attention to the tightness adjustment to avoid uneven thickness and bending, and weave to the waistband head.
The ninth double-loop system method
First, put a figure-eight ring on the belt, repeat the figure-eight ring, and then use a string to pass through the hole in the middle. This is easy. After the tape is finished, it will leave a part of the length of the tape.
Tenth snowflake system method
Stretch out the index finger and middle finger, wrap the string three times, pass through the inside of the finger, come back and pass through the coil on the other side, and adjust it into a snowflake shape after tightening.