Main line: wear two space beans first, then the floating seat, then three space beans, then the lead seat and then the space beans. Four space beans above and below the floating base are used to control the floating position and mark the water level. Two spacer columns above and below the lead base are used to fix the position of the lead base. After wearing it, connect the main line at one end of the lead base with another ring of the eight-character ring, and the main line is completed. According to the length of the fishing rod you use, measure the length of the main line with a rod. The main line is preferably about 10cm longer than the pole. The other end of the main line is folded back and tied in a knot to make a ring, and a knot is tied above the ring to make a small ring at the upper end of the ring. Tie a knot (as far as possible) on the soft rope in front of the fishing rod. When the main line is connected to the fishing rod, use two fingers to pass through the double-stranded line between the two knots and then wrap it back from the outside, so that the double-stranded line is a loose buckle and can be used after being buckled behind the dead knot on the nylon rope slightly above the fishing rod. After use, you can untie the buckle by pulling the knot on it.
To tell the truth, it's a bit complicated, but it's actually very simple to watch someone tie it once. Do a good job of finding friends to tie it for you, and read it several times before you get familiar with it.