2, then make a pot of thick cement slurry for later use.
3. Before laying bricks, wet the place to be paved with water.
4. Shovel the mixed cement and sand to the place where the tiles are to be laid.
5、? After shoveling, initially smooth it with a small shovel.
6. Then smooth the surface with a small flat plate.
7. Then put thick cement slurry on the back of the tile.
8. Then carefully put the pasted bricks in the place to be paved, and pay attention to the joints.
9, reoccupy small rubber hammer, leveling with a level.
10. Finally, seal the side with the handle of a small hammer. It's done.
Extended data
characteristic
The physical characteristics of floor tiles are mainly as follows:
1. dimensional deviation: measure the length, width and thickness of the brick with vernier caliper or steel ruler (national standard: the deviation between the average size of four sides of each brick and the working size), and the national standard is ≤ 0.6%.
2. Surface quality: The front of the brick shall be paved upwards not less than 1 m2, and the light of each part shall reach a certain standard, and then it shall be visually inspected within the specified distance.
3. Among many floor decoration materials, floor tiles have become consumers' first choice. Because it has the advantages of solid texture, easy cleaning, heat resistance, wear resistance, acid and alkali resistance, water seepage and so on.
Maintenance and cleaning
1, for the general dirt of white floor tiles, it is better to wipe with dry cloth than with wet cloth; Wet cloth will leave moisture after wiping, and the surface will be stained. Wipe it with a dry cloth, the brighter it is; Used in ink, rust, animal and vegetable oils, coffee, beer, etc. Can be removed with detergent and washing powder. Some brands are equipped with special cleaning agents, and the cleaning effect is better.
2. After the bedroom wooden floor is waxed, the mop can't be directly used to clean the tiles, and the dirt stained with wax is easy to pollute the tiles and difficult to remove. Generally, the sales staff of the manufacturer need to use professional cleaners.
(1) If it is stained with rust, you can drop fresh lemon juice on the rust and rub it repeatedly, and then wash it with soapy water. If there is no fresh lemon, you can also use vitamin C tablets instead.
(2) If it is stained with soy sauce and vinegar, you can use toilet cleaner.
(3) If the ink seeps in, try toothpaste.
(4) stains such as tea, ice cream and beer can be removed by soda solution such as sodium hydroxide or potassium bicarbonate. Use a board brush instead of steel balls when handling, otherwise it will scratch the surface of the tile, and it will be difficult to handle it if it is stained again.
Maintenance point
1. If the surface is spotted due to burning, it can be lightly polished with fine sandpaper, and then coated with sealant and polishing agent to restore the original state.
2, daily cleaning, you can use ordinary mop as wet as cement floor, and then dry the water with a dry cloth.
References:
Baidu encyclopedia-floor tile