take off
After the plane is turned on and connected to the remote control, it can take off in any of the following ways:
Automatic takeoff
DJI fly
Click the "One-button Take-off" button on the left side of the App flight interface, and then press "Take-off" for a long time, and the plane can take off.
Please click to enter a picture description.
DJI go 4
Click the "one-button take-off" button on the left side of the App flight interface, and then slide to the right according to the page prompts, and the plane can take off.
Please click to enter a picture description.
Artificial takeoff
After the plane is turned on, as shown in the figure below, the remote controller will be knocked for about 2 seconds, and the blades will start to rotate. Hit the rising pole again and the plane can take off.
Please click to enter a picture description.
* Take the American hand as an example. The rising lever is the left rocker of the remote control. Push the rocker up and the plane can take off.
Please click to enter a picture description.
land
Automatic landing
The plane returns near the "return point" and can land in the air. Click the button on the flight interface of DJI Flying App, and then press and hold "Landing". (DJI GO 4 is the "slide button to the right") The plane enters an automatic landing.
Manual landing
After the plane returns, or needs to land after the flight (at this time, the plane is already in the air where it can land), you can press the left rocker and the plane will slowly descend. When it drops to the ground, the rocker will be pressed for about 3 seconds to stop the motor and the plane will land.