1, get ready to stick needles and wool, and make a demonstration starting with 50 needles; In the specific weaving, the hat should be based on the actual size of the head circumference.
2. Start knitting, with one needle for the upper needle and one needle for the lower needle, so as to distribute the loops on the three needles.
3. Then continue to knit the upper and lower needles after the head and tail are connected; Just weave it to an inch. The edge of this hat is knitted.
4. Then start knitting the hat body, and change the needle to knit with the lower needle.
After the hat is woven to the required length, the needle will close.
6, needle collection method: first knit a needle and then knit two needles and one needle, so you received a needle. This cycle goes back and forth.
7. Then continue to knit the second lap and the third lap according to this method ... When there are still about 10 laps on the stick needle, stop taking up the needle.
8. Then leave 10 cm of wool and cut it off.
9. Thread the wire into the coil and tighten it from the back.
10, after tensioning, as shown in the figure below.