Floating is almost indispensable for hand fishing, and floating is also indispensable for sea fishing. The floating response is very sensitive. When the fish touches and swallows the bait hook, the position of the bait hook will change, and this change will be immediately transmitted to the floating body through the fishing line.
Different fish have different feeding habits and have different reactions to floating. Experienced anglers can roughly judge what kind of fish bites the hook according to the different reactions of the float. So we can see how important floating is. Today I will teach you how to make floats by hand from several aspects.
1. Material selection: A drinking straw with appropriate length and thickness should be selected, with a length of 15-20cm and a diameter of about 2-3mm, and the tube body is bright white and undamaged. Choose a small piece of automobile inner tube film with good elasticity, which cannot be used by those who are aging and inelastic. A section of valve core hose of bicycle.
2. Manufacturing method of components: 1. When manufacturing, after baking one end of the drinking straw with a small fire, quickly pinch a small piece of cloth with your thumb and fingers at the baking place and gently rub it to make the hose hole stick and seal. According to this method, seal the other end of the straw, then dip it in red paint with a small combination brush or cotton swab of 1, and draw a red cover on the bleaching tail.
Then draw a few small red squares at an appropriate distance under the red cover. (It can be made according to the vertical floating grid sold). So the bleaching process was completed without spending a penny. After drying in the shade, this small vertical float can be used for assembly and fishing. 2. Use scissors to cut two long colloidal particles about 0.5 cm long and the size of mung beans from the elastic inner fetal membrane instead of space beans.
3. At one end of the valve core rubber hose, cut two valve core aprons with a length of about 0.3-0.5cm to replace the floating seat.
3. Installation method: 1. When assembling, use a fine needle to pass through the bus bar at one end of the bus bar, and then thread the needle from the long end of the first rubber particle to the long end (this can better keep the rubber particle on the line). Pass the two small rings of the valve core through the pins on the bus bar. 2. Put the second rubber particle on the bus according to the above method (two valve cores are between the two rubber particles).
After removing the fine needle, tie a hook at one end of this busbar (the size of the hook is determined by the needs and habits of the fisherman). 3. Finally, insert one end of the punch into two valve core rings, and place the upper rubber ring directly above the punch 1/3. Put another apron on the floating head and tie it to the fishing line. Thus, that assembly of the salvage group is complete.
When fishing, after adjusting the water level and drift distance, the colloidal particles move to the upper and lower buses of the two circles of the valve core with adjusted drift position respectively, and the drift position is firm and reliable, and the drift will never slide down.
Advantages of bleaching
1, easy to obtain and simple to make.
2. It has the advantages of light weight, high buoyancy, uniform length, and good wind and wave resistance. Coupled with this sensitive floating body and eye-catching red and white plaid, the fish bites obviously, and the elderly fishermen with poor eyesight can accurately observe the drift and lift the pole in time.
3. Durable and not easily damaged. After comparative salvage, its service life is more than twice that of ordinary vertical floats sold in the market. It is an economical, time-saving and time-saving three-province drift, and is also suitable for any fishing tackle fishing group.