(1) Geely emgrand EC7 18 belt diagram Geely emgrand EC7 18 belt diagram is the standard position diagram of the official vehicle organization. To calibrate this timing system, the crankshaft, camshaft, balance shaft and oil pump wheel must be aligned with the marked positions of the engine block. The specific operation steps are as follows:
1. Turn the crankshaft timing wheel set and mark it.
(2) How to install the belt of Emgrand ec7 18 can be installed by the following methods.
Tools needed: wrench. First, loosen the main shaft of the generator with a wrench, so as to wind the belt easily. Extended reading of Emgrand engine belt installation drawing: There are two installation methods in the market: one is an independent tire pressure monitor with a screen, which generally uses a cigarette lighter to get electricity and take the open wire. Many lines are exposed, which affects the beauty of the car and blocks the driver's line of sight, which is a bit inconvenient. The other is that the image AV recorded by the driving recorder is output to the on-board DVD, and the images are displayed synchronously.
How to assemble the Emgrand engine belt is easy to install. I don't know. If the winding is incorrect, the length will be different. Give it a try. Ask the car master. 4S shop professional technician, 10 minutes to solve. How does the generator belt of Geely Emgrand 4g 15 engine wind on the generator belt? Lift the car with the elevator, remove the right front wheel, pull open the wheel cover, thread the belt from bottom to top, hang it on the upper wheel, and then clip it into the belt position at the lower tensioner.
How to install the generator belt of Geely Emgrand 4G 18 engine? This needs to be sent. The tight wheel pump is driven by plane, and the rest is easy to figure out how to install the generator belt of Emgrand 4G 18 engine. Geely Emgrand's engine is imitation of Toyota 8A, and its quality is quite good. The oil consumption of new and old cars is similar, the failure rate is low, and the quality of other parts is average. Installation steps of Emgrand engine belt: fix the tensioner with a hexagonal sleeve, remove the bolt with a wrench, and adjust the tension after installing the belt to make the one-way jump less than 2cm. How to install the generator belt of Emgrand 4G 18 engine? The belt can be installed by the following methods. Tools needed: wrench.
1. First, loosen the main shaft of the generator with a wrench to make it easy to wind the belt.
(Photo/Text/Photo: Ask and Answer Animals) @20 19