Tools: Prepare hook and suitable fishing line. In order to ensure the shooting effect, I chose a bigger hook and a thicker fishing line. In the actual hooking process, the length of the fishing line is determined according to the parting line length required by the fisherman himself.
Method:
1. Hold the hook with your left hand and bend the fishing line into a circle as shown in the figure. Pay attention to leave enough length at the ends of both sides.
2. Hold the right wire of the coil interface with your right hand and wind the fishing line on the hook handle. Note that the right thread end and hook handle should be wound together at the same time.
3, a total of 4-5 laps can be wound, not too much.
4. After winding enough times, hold the winding with your left hand, as shown in the figure, and then hold the thread end of the winding with your right hand to pull it out.
5. Pull it all the way to the back of your head and tighten it hard. At the same time, pay attention to avoid excessive force at the hook tip to hurt your hand. It is also important to make the direction of the fishing line drawn on the inside of the hook handle as shown in the figure, because the head fixing piece of the hook handle is inclined outward. If the fishing line is left on the outside of the hook handle, it will often cause the hook handle fixture to wear the fishing line, which will lead to the deviation of the fish.
6. Finally, subtract the extra thread with scissors.
7. The hook at one end of the sub-line is knotted, and the hook at the other end can also be used in the same way.