1, distance between sprinkler mixing valve and ground.
It is usually controlled in the height range of 90 to 100cm. In this range, the owner can also make fine adjustments according to his height. But generally it should not be higher than 1 10cm. If it is too high, the lifting pipe of the shower head may not be installed.
2. Reserved height of shower faucet
When laying pipelines, first of all, we should consider the reserved position, which is generally 15mm higher than the blank wall, so that the thread ends can be buried when sticking ceramic tiles to ensure the beautiful wall surface.
3. Space reserved for the inner wire elbow of the shower head
However, the distance between the electric wire elbows in the shower is generally around 10 ~ 15cm.
Precautions for installing shower head:
1. When installing the shower, it is necessary to punch holes, but it should be noted that the water pipes in the wall cannot be punched during the punching process.
2. When installing the round bottom cover, be sure to tighten the screws, otherwise the shower head will easily fall off.
3. When installing the hand-held shower, you can't tie a knot or twist it.
4. Before installing the shower, be sure to determine the installation height and make records.
Extended data:
Precautions for installation
All kinds of impurities in the pipeline should be thoroughly removed during installation. The damage, blockage, blockage and leakage of the valve core can be avoided. At the same time, the surface should be cleaned, leaving no building materials residue.
For any kind of faucet product, you don't need to use too much force when opening and closing, just twist or poke it gently. Even the traditional faucet can be screwed to death without much effort.
In particular, do not support or use the handle as an armrest. Products with a mesh cover at the water outlet should be disassembled and cleaned after a period of use to remove impurities. For products equipped with hoses, care should be taken to keep the hoses naturally stretched to avoid breakage.
The metal hose of the bathtub faucet shower head should be naturally stretched, and should not be coiled on the faucet when not in use. At the same time, whether it is used or not, be careful not to form a dead angle at the joint between the hose and the valve body, so as to avoid the hose being broken or damaged.
After the faucet is used for a short time, sometimes it will be incomplete, leaking, loose handle, loose joint and leaking. Under normal circumstances, consumers can solve it by themselves.
When the spiral rubber nozzle is not completely closed, it is usually because hard impurities are stuck in the sealing mouth. Just remove the handle (handwheel), unscrew the valve cover and valve core to remove impurities, and then install it as it is, and it can resume normal use.
When the sealing nozzle of the ceramic valve core is not completely closed, hard impurities may scratch the sealing surface or the pre-tightening force on the valve core is insufficient.