How to wear the license plate screw cap?

Steps for putting nuts on car license plates: 1. Insert the screw into the hole. When inserting, you need to turn the screw to insert. Be careful not to insert it backwards; 2. Screw the prepared screws into the screw holes as shown in the figure. This step requires a screwdriver. Note that this kind of screw can only be screwed in, not out, and it must be successful once; 3. After tightening, gently press the anti-theft cover, as shown in the figure below. This kind is disposable, once pressed in, it can't be taken out; 4. Tighten all four screws as above; 5. The screw holes of the rear license plate will be sealed with glue before installation to prevent foreign objects from entering. Just tear it off when you install it.