1, side knot method-the shoelaces pass through the bottom two holes of the shoe, and the shoelaces on both sides have the same length, then the shoelaces on one side pass through the outer holes in turn, and finally meet at the top two holes and tie them.
2. Punching and jumping method-after the shoelaces pass through the two holes below, the shoelaces on one side pass through the two holes on the opposite side, and the methods on both sides are the same. Just tie the shoelaces on both sides.
3. Internal knotting method-pass the shoelaces through the holes on both sides and pull out the shoelaces from the inside out; The pulled shoelace is inserted into the second hole from the outside, the left shoelace is inserted under the shoelace between the two holes on the right, and the right shoelace is similar. Just tie the shoelaces on both sides.
Spiral lacing at the end of shoelaces:
0 1. Tie the shoelaces in the usual way, and then bend them at the ends. The length of the bent shoelace needs to be selected according to the length of the shoelace, generally bending at one third of the remaining shoelace.
02, according to the way of winding, on the point of shoelaces. At the bottom of the position where we just bent, we circled upwards. It should be noted that when we turn around, the tightness should be appropriate. Too loose or too tight will affect the beauty of shoelaces.
03. Continue to turn upward in the same way, leaving a small hole at the top of the shoelace. If you continue to turn upwards, the shoelaces will easily slip off. So the position of the circle should not be too close.
03. Continue to turn upward in the same way, leaving a small hole at the top of the shoelace. If you continue to turn upwards, the shoelaces will easily slip off. So the position of the circle should not be too close.