According to Article 10 of the Measures for the Supervision and Administration of Special Equipment Operators (Order No.70 of the General Administration of Quality Supervision, Inspection and Quarantine), the applicant for the certificate of special equipment operators shall meet the following conditions:
1, age 18 years old or older;
2. Be in good health and meet the special requirements of the type of operation applied for;
3. Have an education level suitable for the application type;
4. Have work experience suitable for the type of application,
5, with the corresponding knowledge and skills of safety technology; (If not, you need to be trained first)
6. Meet other requirements specified in the safety technical specifications.
First, test pile
(1) "8" driving field test:
Site size: A=2 times vehicle width+1200 mm B= vehicle length.
C= vehicle width +600 mm D= vehicle length.
R=2 times wheelbase length +600mm r= wheelbase length.
Driving route: When driving empty, the forklift will drive out of the garage to 1, reverse from 1 to 2 (garage a), advance from 2 to 3, retreat from 3 to 4 (garage b), advance from 4 to 5 for 8 words at a time, travel from 6 to 7, reverse from 7 to 5 for 8 words for the second time, and return to the garage from 6.
Technical requirements:
1. Vehicle requirements: Forklifts generally use 2 tons or 3 tons of forklifts. The structure and equipment are complete, and the technical condition is good. Has passed the inspection of Guangzhou Municipal Bureau of Quality and Technical Supervision, with complete licenses.
2. Site requirements; The size of the site must conform to the size parameters of the vehicle model, and the ground should be flat and solid without obstacles. Safety signs and signs should be set around to ensure that the site and equipment are dedicated to inspection. Safety operation procedures, examination room rules and sun-shading and rain-proof facilities should be hung in a conspicuous place on site.
3. Time requirement: 4 minutes. Timing starts from the forklift driving to the completion of the "8" driving assessment of the whole audience and ends when people leave the cab. Require signals at the beginning and end.
4. On-site marking requirements: Brush with yellow paint with a line width of 50 mm ..
5. On-site benchmarking requirements: pile head height 15cm, rod hole diameter 40mm, and fan-shaped cast iron pile head designated by the examination committee shall be adopted to ensure the stability of the benchmarking and prevent the pile head from being squeezed by wheels and flying out to hurt people. Column height 1500mm, red and white, spacing of 300mm.
References:
Baidu encyclopedia-forklift driver's license