Do you need to sew under the toilet?
1. The bottom of the toilet needs sewing. Do not use sealant instead of glass glue to seal the edge around the toilet. Their main properties are different because of their different compositions. Glass glue is mainly composed of sodium silicate, acetic acid and silica gel, which has strong flexibility and adhesion; The caulking agent is composed of epoxy resin and curing agent, which mainly plays an aesthetic role and has certain cohesiveness. Sealant is not only less adhesive than glass glue, but also more expensive.
2. The caulking agent has the advantages of being as hard, waterproof, mildew-proof and pollution-resistant as porcelain, but it can't be soaked in water for a long time, otherwise it will affect the service life of the product; However, there is a lot of water vapor and humidity in the bathroom, which is not suitable for using sewing agent products.
3, the use of glass glue around the toilet is not serious, we can pour a little toilet cleaning spirit in the moldy place, and clean it with a toothbrush with waste gas later. Or we can put the cloth soaked in 82 disinfectant in a moldy place and clean it overnight. Glass glue is mildewproof, and we can also use special mildewproof products for cleaning.
How to install the toilet
Check the ground drain pipe, install the toilet outlet pipe, and install the water tank elbow at the mark. First, check the ground drain to see if there is any garbage accumulation inside. If so, be sure to check and clean it up carefully. If it is not cleaned properly, it is likely to cause problems such as toilet blockage.
1. Install the toilet. First try to install the outlet pipe of the toilet, mark the bolt hole of the toilet with a marker, and then remove the toilet. Open a hole with a height of 6cm at the marked place, which is directly 1.5-2 cm, and then screw the bolt of 1cm into the hole with cement. Then put the toilet on it to see if it matches, and remove the toilet after inspection. Then apply putty around the toilet outlet pipe and sewer pipe buckle, and then align the bolt holes with the twisted bolts and straighten them.
2. Install the toilet in the same way as the third step. According to the position of the two holes on the back of the water tank, make a hole with a diameter of 3cm and a height of 7cm, and then screw the bolt with a diameter of 1cm and a length of 10cm into the hole with cement. Then hang the water tank on the bolt, straighten it and tighten it. Remember to pad the bolts with leather pads. When the installation is in place, we need to install the water tank sewer elbow, remove the nuts of the rear water tank sewer and the toilet inlet, install them on the upper part of the sewer elbow back to back, and then put on the rubber pad. Then install the upper end of the sewer elbow with the sewer outlet of the rear water tank, insert the lower end into the toilet inlet, and tighten the nut.
3. Install the toilet, measure the drift of the water tank and the size of the water pipe mouth, match other parts, then put the splayed door into the water pipe, and then put the drift door and splayed door nut back on the copper pipe. Finally, lead oil rope is wound on both ends of the pipe, and then the diameter and splayed door are inserted, and the nuts are tightened.
Do you need a nice seam under the toilet I introduced to us? How to install the toilet? But glass glue is used around the toilet. After all, if the toilet uses glass glue for self-maintenance, it will avoid odor, because the strength of beauty glue is not as big as glass glue. So if you choose glue, you can use it under the toilet, but it is best to use glass glue around it.