Step 1, roll the float to the end, let the lead base go straight to the end, observe how many eyes the float is exposed to the water, add the length of the auxiliary line, and subtract the length of these two to get the water depth.
Step 2, adjust two floats in the direction of the lead holder and start cutting the lead. If the distance is reduced by two floats, the floats are still exposed to the water, which proves that lead is light. You can add some lead to make the float 5 ~6 meshes above the water. According to your float material and size model, you can adjust the thick-tailed float to 4 grids for 2 grids, the soft-tailed float to 6 grids, and the hard-tailed float to 5 grids.
Step 3: If the float sinks directly, cut the lead skin happily according to the sinking speed. The sinking speed is fast. You can cut more points for the first time, and then trim it slowly and cut it into the grid above.
Step 4, adjust the float to two floats at the tip of the pole, rub the bait to see the number of floats exposed, and slowly adjust the float to 2~3 meshes. This bleaching method can be rubbed.
Extended data:
General drift adjustment method 3+ 1 program:
1, determine the appropriate empty hook adjustment. For example, 5 mesh.
2, hang a single bait, see single bait eye adjustment. Such as 1 mesh.
3. Determine a suitable fisheye. For example, 2 mesh (generally between empty hook adjustment and single bait adjustment).
4, strain. For example, changing the fishing list to four will reduce the sensitivity and empty hook rate of the fishing group.