The diagram of how to install the fishing rod is as follows:
1. Tie the main line and rod tip: First of all, the first thing to do is to prepare all the tools. In addition to fishing rods, there are also fishing lines, space beans, lead seats, etc. The first thing to connect is the main line and the pole. First put a figure-eight ring on the pole rope, then fold the rope and tie it with fishing line. You can tie it by hand-tying the fishhook, which will make it stronger.
2. Tie the main line: Then tie the main line. First, insert a space bean into it, fold the fishing line in half, then push the space bean up, then insert two space beans, the floating seat, and then insert the space bean. It is also necessary to insert a space bean and a lead leather seat at the end of the fishing line, and then fix the lead leather seat.
3. Tie the fishhook: The last thing to install is the fishhook. When installing the fishhook, you need to pay attention to keeping the hook handle of the fishhook facing forward, slowly wind it with fishing line, let a section of thread pass through it, and the fishhook is tied. In this way, even if the fishing rod is basically tied, the fishing rod can be used.
4. Protective cap: an accessory specially used to fix and protect the guide eye when the fishing rod is contracted. Generally, there are straight protective caps, triangular protective caps and special protective caps for rock fishing rods. The colors include transparent, translucent, black and gun smoke. The protective cap should be consistent with the thickness of the fishing rod. If it is too large, it will easily fall off and break the guide eye. A protective cap that is too small is easily damaged and may damage the guide eye, so neither too large nor too small is a good idea.
5. Guide eye: also called wire loop or guide ring, it is an accessory specially used for running fishing lines. It requires high strength, low friction resistance, good thermal conductivity, and consistent with the fishing properties of the fishing rod. A general guide eye consists of a bracket and a wire ring. The bracket is made of stainless steel and must not rust and cannot be too soft. The wire ring is mostly made of ceramic rings and silicon carbide.
General wire rings have one or two center rings, with two center rings, the middle ring is made of ceramic, and the outer colored ring (also called a vibration-absorbing ring) is made of plastic. It is generally a lower grade guide eye; the guide eye with only one center ring is a higher grade, and the material is generally silicon carbide.