The bus door remote controller uses the latest technology to encode and decode, and controls the door pump solenoid valve in a flashing way to close the automatic door. Used to remotely open and close the doors of buses (buses, CMB), avoiding the trouble that drivers need to get on the bus to open the door every time.
How to install the bus door remote control?
After installing the garage door opener, please be familiar with the assembly of parts. To install the garage door opener, first insert the pipe into the power unit. Put the passengers on the pipe, and then load them into the pipe idler assembly. Passengers at the location specified in the manufacturer's instructions.
Connect the passenger chain, bypass the drive sprocket and idler assembly, and then return to the other side of the passenger chain.
The chain is connected to the passenger, and then circulates around the idler device through the driving sprocket on the power supply unit, and returns to the passenger at the other end. According to the manufacturer's specifications, passengers must be positioned and the chain must be properly tightened.
Install the idler assembly on the upper garage door head bracket according to the manufacturer's instructions.
Precautions for installing the door remote controller:
Preparation before installation. Make sure your garage door is well lubricated and working properly. The weight of the garage door is supported by the door spring, cable and pulley, not in the opener. If you can't lift the door, put down your usual hands and don't install the opener until the door is repaired.
Do not modify or delete the spring, cable or pulley of the door. The door spring (single coil) above the door can only be provided by qualified technical service personnel.
Delete all connected ropes or wires during installation, so that you won't get entangled in their garage door.