The course of the diamond knot rope bracelet is as follows:
1. Material preparation
It is necessary to prepare a black A jade thread (diameter 1mm), a silver foil colored glass pink bead (diameter 1mm), two gold receptacles and a purple colored glass bead (diameter 8mm). Tools include scissors, lighters and tape measure.
2. Making the buckle ring
First, fold the black jade line A in half, and adjust the length, with 75cm on one side and 125cm on the other. After that, wrap the jade wire in half for 2.5 ~ 3 cm. Then take the 75cm line as the axis and wind the 125cm line to make a pipa knot. Insert the winding into the hole of the last turn to complete the pipa knot. At this point, there are two ropes on the back of the pipa knot.
3. After making the diamond knot
, wire it with gold thread to fix the knot. Start knitting a diamond knot, about 3cm. Then twist two braids (3cm) and continue to weave the diamond knot (3cm). Repeat this until it is close to the wrist size.
4. Ending
Finally, two braids are wrapped around gold thread, and then they end with a new knot. Use scissors to cut off the excess thread, and use a lighter to melt the thread and stick it tightly. At this point, the diamond knot braided rope bracelet is completed.
that's the tutorial of the diamond knot braided rope bracelet. It is suggested to adjust the size and quantity of the diamond knot according to personal preference and the length of the bracelet.
Method of knitting rope bracelets
1. Knitting method 1
First, take a colored thread, cross it, with one end in a small circle, then turn one of the single threads into a figure of eight around the cross part, and when the length is almost the same, tighten the other end to adjust it, and finally connect the two ends together.
2. Method 2
Take two colored lines and divide them into A line and B line. Wrap the line A around the line B in a circle, and then the line B will go out of the circle in a counterclockwise direction. After tightening them, repeat the above steps.
3. Weaving Method 3
First, prepare a black colored rope, fold it in half, and then set a slipknot, without having to fold it in half from the middle. Next, take another black colored rope, wrap it around the main body for a while and then fix it, and then take a white rope and wrap it around the main body for a while and then fix it. Then the black and white colored ropes are alternately wound, and finally the two ends are connected together.