1. Hold down the intersection of two lines, take a hook, put the hook in front of the short head, and control the length of the short head, which is about as long as the hook handle. Grab the big coil and start winding the first and second turns. We can wrap it around the hook handle for about 8- 10 turns.
2. After winding, we will stir up the coil, hold down the hook handle with the middle finger and thumb to take up the thread, control the small coil, pick up the short thread end to clamp the hook, pull the wound coil back to the hook handle, clamp the small thread end and turn it over and tighten it.
3. After tightening, make sure that the long and short ends are located inside the hook handle and in the same line. Finally, you can cut off the short end with scissors.