Take the most widely used spinning wheel as an example. For the convenience of taking pictures, take the flying standby line as an example. ?
First, fold the fishing line in half, as shown in the figure?
Bend the folded fishing line back again to form a coil as shown in the figure.
As shown in the figure, the bent thread end penetrates into the coil just formed by itself, which is equivalent to winding the two folded threads for the first time. Repeat the previous step and wind it for 3-4 times. ?
After winding is completed, pull both ends of the knot with both hands as shown in the figure to tighten the thread end. ?
After tightening the thread end, cut the remaining thread with scissors. By this time, we have already laid a looper coil, and the knot of the looper part is also very strong. ?
After opening the cup holder of the spinning wheel, put the looper we just tied on the cup. As shown in the figure.
Tighten the fishing line as shown in the figure, so that the looper can be tightened on the thread cup of the spinning wheel. ?
The last step is to close the wire cup holder and start winding.