Preparation materials: small rubber bands of various colors, a U-shaped frame, a small crochet and an S-shaped buckle.
1. First, prepare small rubber bands of various colors, a U-shaped frame, a small crochet needle and an S-shaped hook buckle.
2. Pick up the USB flash drive, point the groove of the USB flash drive at yourself, and start.
3. Pick up the first colored rubber band and put it at the bottom of the U-shaped frame, paying attention to the figure-eight placement.
4. Place the second and third colored rubber bands in parallel above the first colored rubber band.
5. Pick both ends of the first colored rubber band with crochet and pull it up.
6. Put the first colored rubber band on the third one.
7. Put a colored rubber band on the U-shaped frame in parallel.
8. In the same way, pick the bottom to the top.
9. Repeat this operation until the braid is long enough to wrap around the wrist.
10, the final outcome, can be connected with S-button.
Second,
Material: rubber band.
Step 1: First, prepare small colored rubber bands, preferably a little in any color, so that the braided bracelet looks good. Cross a small rubber band on your finger.
Step 2: Take out two small rubber bands and put them directly on your fingers. Choose the color of the rubber band. Generally, the more colors, the better the finished product.
Step 3: As shown in the figure; Transfer the rubber band that was crossed between your fingers to the small rubber band that you put on later.
Step 4: Continue to put on colored rubber bands, and continue to repeat the above steps of crossing and rotating rubber bands. Repeat the above steps for all subsequent steps. Until the bracelet is the right size
Step 5: After knitting to a size suitable for wrist wear, we can remove the knitted rubber band from our hands, as shown in the figure; Tighten the last rubber band.
Step 6: Finally, we tie the two ends of the rubber band with a dead knot, and a beautiful and practical "rubber band bracelet" is woven.