(1) Take out the pipe plug of the ground sewer, check whether there is debris accumulation in the pipe, and then clean the nozzle.
(2) Align and straighten the water outlet pipe of the toilet, then mark the bolt hole of the toilet and remove the toilet.
(3) Make a hole with a diameter of 15-20mm and a depth of 60mm at the mark, then insert a bolt with a diameter of 10mm into the mouth, screw it firmly with cement, tighten the bolt to match the mark, and remove the toilet after the test. Apply putty around the toilet outlet and sewer pipe, then align the four bolt holes of the toilet with the bolts, put them straight, put rubber pads on the bolts, and screw the nuts until the tightness is moderate.
(4) aim at the center and tail of the toilet, draw a vertical line, draw a horizontal line at a height of 750mm from the ground, draw a mark on the horizontal line according to the position of the two side holes on the back of the water tank, and make a hole with a diameter of 30mm and a depth of 70mm at the printed hole. Insert a bolt with a diameter of 10mm and a length of 100mm into the hole and tighten it with cement. Hang the back water tank on the bolt, straighten it, especially aim at the center of the toilet, put a rubber pad on the bolt, and screw the nut until the tightness is moderate.
(5) When installing the elbow of the sewer pipe of the rear water tank, first remove the nuts of the outlet of the sewer pipe of the rear water tank and the water inlet of the toilet, put them back to back on the elbow of the sewer pipe, and put rubber pads on the sewer pipe respectively. Insert the upper end of the water elbow into the water outlet of the rear water tank and the lower end into the water inlet of the toilet, then push the rubber pad to the water outlet, screw on the nut, straighten the water elbow, and screw it with pliers until it is moderately elastic.
(6) Finally, when connecting the water supply and the splayed gate, measure the size of the water tank drift gate from the nozzle of the water supply, match the nipple, install the splayed gate and put it into the nozzle of the water supply. Cut the copper pipe or plastic pipe, and bend the fork appropriately. Then put the nuts of the floating door and the splayed door back to back on the copper pipe or plastic pipe, wrap the asbestos rope or lead oil hemp thread on both ends of the pipe, insert them into the entrances and exits of the floating door and splayed door respectively, and tighten the nuts.
The installation of the toilet is directly related to the later use, please pay attention. If you think it is helpful, please adopt it.