Weaving method of copper bracelet

First, the jade line pair of 150cm is folded into two pieces, and a small circle is left above the fold. Then when the diamond knot is about 15cm, the line below the diamond knot will pass through the small circle at the top, and then a double connection will be made 3cm below the diamond knot. Finally, five copper coins were made by crossing the jade lines of 100cm.

The knitting method of the copper bracelet is to first fold the pair of 150cm jade thread into two pieces, and then reserve a small circle at the top of the fold. Then weave the diamond knot back and forth to 15cm, and the two threads under the diamond knot will pass through the reserved small circle.

At this time, there will be a diamond knot ring on the top of the bracelet, and then continue to weave the two threads under the ring. After weaving a diamond knot with an appropriate length, make a double knot at the bottom. The length of the double knot is about the width of four jade lines.

Take out four 100cm jade threads and thread them side by side into the gap left by the duplex and diamond knot. Then, the jade thread with diamond knot continues to double, and the interval between each double is 3cm.

The four jade lines at the bottom are crossed by a double connection. At this time, there will be the shape of copper coins, and then continue to weave diamond knots according to the width of your wrist, and finally tie a knot.