Take out the rope to be completed, cross-wind the ends of the two ropes twice, and the ends of the ropes pass through the loops to tighten the coils. Both sides did the same thing, except for cutting the thread and ironing the felt.
Precautions for beaded bracelets:
1. Prepare materials and tools for weaving bracelets. The thread diameter is 0.08 mm. There are five red ropes, and the number of beads is unlimited. The best choice for wiring is red beads. First, arrange four red ropes of equal length in a row and tie them in a knot. Be careful not to tie it too tightly.
2. Start knitting diamond knots. First take two lines at random on the side, and then make a circle with a line above your finger. The circled line does not move, and the other line is wound from the bottom of the index finger and passes through the upper circle. Tighten the first thread. After tightening, put the ring on the index finger and repeat the above steps in turn.
3, learn to weave diamond knots skillfully, and often weave diamond knots, depending on the size of the beads. After knitting 10 pieces, put beads on the other two threads.
4. Don't use two threads as a group of threads, and then the two groups of threads start to weave diamond knots. Note that these four threads are woven into a diamond knot at the same time. After knitting, the thread will be a little loose, and then it will be tidied up a little. Try to shorten the two lines with beads.
5. Repeat step 2.3.4, etc. All the time, but pay attention to the direction. Two threads woven with diamond knots for the first time will be beaded in opposite directions for the second time. The two strands of beaded knots will be woven with diamond knots and then appear alternately until they are woven to the desired length.
6. Prepare another thread first. Then put the threads at both ends of the braided bracelet together, with one thread on one side and the other thread on the other. As far away as possible. After straightening the thread, fold the other thread in half and weave a flat knot with the eight threads of the bracelet as the axis. After editing, cut off the extra lines.
7. For the residual line at the end, there are two ways to choose. One is to thread beads on the tail line. The second is braiding, braiding eight-character knots, also known as phoenix tails.