First, how to install integrated wallboard-tool preparation
Tools for installing the integrated wall include impact drill, electric M6 set, electric screwdriver, aluminum cutter, hand cutter, pistol drill, hole opener, needle-nosed pliers, M 14 open-ended wrench, hammer, Mo Dou, air nail gun, nail row, silica gel wire, tape measure, glue gun, white beauty agent, glass glue, electrical tape, industrial alcohol, tool knife, etc.
Second, how to install the integrated wallboard-preparation of the installation board
Before installation, select the appropriate worksheet or personalized style according to the owner's design style. Then according to the shape and size of each space, prepare the whole wallboard and accessories.
Third, how to install the integrated wallboard-installation steps
1, clean up the decoration site
Clean up the site construction waste and create a safe and secure construction environment. The wall must be flat, and the local concave and convex parts must be filled or leveled.
2. Measurement area
According to the design scheme, measure the installation area of wall and ceiling, and choose the appropriate product size according to the actual situation on site to avoid unnecessary losses during installation.
(1) According to the estimation of the traditional wall coverage area, it is three times of the land area, including the wall and the top surface, and the basic installation area is in this area.
(2) Accounting method for measuring the actual area of the family: According to the actually measured area, after completing the rewinding, the height from the top to the ground is basically guaranteed to be no less than 2.75m, and the maximum can be guaranteed after accounting. Eliminate unnecessary wear and tear during installation.
3. Frame elastic line
According to the pattern of the whole wall, determine the laying method of keel. No keel is required for wall installation. According to the design and size of the building, determine the starting position and joint connection position, and pop up horizontal and vertical lines respectively. According to the size of each part of the building and the length of the whole wall, the keel position and vertical line are determined on the building wall.
4, keel installation
Usually, it is not necessary to install the keel on the wall, but it can be installed directly on the whole wall. Before installing the integrated wall, the ceiling of the ceiling needs to be installed with keel. According to the overall thickness and thickness of the overall external thermal insulation system, it is equal to or less than 50 mm, and the keel wildebeest and keel are less than10 mm. Rubber pads should be used, galvanized keel should be installed according to the position and fixed by expansion bolts. The allowable deviation of flatness and verticality of galvanized keel installation should be controlled within 2.5mm, and the gasket can be adjusted to be lower than the standard parts during installation. The lightning protection jumper of the keel shall be made at the bottom and connected with the grounding bus of the construction unit.
5, integrated wall installation
According to the design drawings and the actual size of the wall, cut the whole wall, and pay attention to the alignment of pattern splicing. According to the horizontal control line, the integrated wall can be installed from bottom to top. The keel can be fixed with self-tapping screws or rivets.
Installation sequence: first big angle, then flat-fell seam, first big wall, then self-closing window arm, and then install with joint coping and other accessories. Except for screws or rivets, all gaps should be sealed with waterproof rubber, and there should be no insulation layer between the integrated wall and keel to ensure reliable lightning protection and grounding.
That's all that Bian Xiao introduced to you about how to install integrated wallboard.