Graphic method of how to weave bracelets with rubber bands

Preparation materials: colored rubber bands and S-buckles.

1. First, wrap the green belt around the middle finger and the index finger to form a cross figure, and then continue to wrap it in pink blue, but there is no need to cross it.

2. Pull the left side of the green rubber band at the bottom of the left side between the top two fingers.

3. Pull the green rubber band at the bottom of the right side between the two fingers at the top.

4. Wrap a yellow rubber band around it again, or pull the pink rubber band at the lower left between the two fingers above.

The pink rubber band on the right is also pulled between the two fingers on the top from below.

6. Repeat the above steps. After weaving to the required length, there is no need to add more rubber bands when only two rubber bands are wrapped around your fingers.

7. Remove the last two pink and green rubber bands from the yellow rubber band, and buckle the rings on both sides of the yellow rubber band on the S buckle to complete the bracelet.