Tools: all kinds of small drills, knives, sandpaper, vajra bodhi.
1, bubble?
In order to prevent the vajrayana bodhi from cracking during cutting, it is necessary to soak vajrayana bodhi in warm water of 50 degrees for a period of time, and it doesn't matter if the time is long. Then use a machete to cut a rough position on Vajrayana Bodhi, which is the position of the final ring. ?
2. cutting?
Then use the serrated knife of a small drill to cut along the previously marked position and remove both ends. Be careful not to cut your hand when cutting.
3. punch in?
Vajra was cut by Bodhi and became a disc. The next step is to get through the interior of Vajrayana Bodhi, polish off the unnecessary parts, select a drill that can pass through the interior of Vajrayana Bodhi, and then polish it bit by bit. Pay attention to the measurement when polishing to ensure that it can be worn on your fingers, and also ensure that the Vajrayana Bodhi is not too thin to avoid cracking. ?
4. Polishing?
After arriving here, the ring of King Kong Bodhi is finished, but if you like the bright feeling, you can use sandpaper to polish the surface of King Kong Bodhi, from low-grade sandpaper to high-grade, and finally the surface of King Kong Bodhi will be bright. ?
5. rounding?
The next process is a more detailed process, that is, the inner diameter of the diamond ring should be polished and decorated into a circle. After all, if it is not decorated inside, it will be uncomfortable to wear on your fingers, but if you feel nothing, you can also choose a round polishing tuo to polish the inner diameter of Vajrayana, and keep it round and smooth while grinding. ?
6. finished product?
Until here, the unique diamond Bodhi ring in the world was made.