1, half knot hook:
Half-knot hitch is the most common way to tie a car. Just wind one end of the rope into a circle, and then put the coupler through the middle of the rope circle.
2, eight knot hook play:
Wind one end of the rope into a circle, then pass the rope end under the rope and come back, and finally tighten the rope end.
3, flat knot hook:
Wrap one end of the rope in a circle, and then put one end of the rope in a parallel position from under the rope. Then put the end of another rope under the loop of this rope, wrap it around it, and then put it back and tighten it.
How to use wire rope hanger;
1. When using wire rope buckle, tighten the U-bolt until the wire rope is pressed to about 1/3. Because the wire rope is deformed after being stressed, it should be tightened for the second time after being clamped into the wire rope to ensure the reliability of the joint.
2. If it is necessary to check whether the rope clamp slips after the wire rope is stressed, a safety rope clamp can be attached.
3. The safety rope clamp should be installed at a position about 500mm away from the last rope clamp, and the rope head should loosen a safety bend before clamping with the main rope, so that if the rope clamp slips, the safety bend will be straightened, which is convenient for being found at any time and reinforced in time.
4, the size of the clip should be suitable for the thickness of the wire rope, the internal clearance of the U-shaped ring is larger than the diameter of the wire rope 1 ~ 3 mm, and the gap is too large to clamp the rope.