Knot the outer ring: first, determine the distance between the double hooks and fold the sub-wire, then wrap the sub-wire around the formed ring for 2-3 times and then pass through the inner ring, and finally gently pull both ends of the sub-wire to make the sub-wire tightly knot. Inner loop knot: firstly, determine the distance between the double hooks and fold the sub-thread, then wrap the sub-thread around the formed loop for 2-3 times and pass through the inner loop, and finally gently pull both ends of the sub-thread to make the sub-thread tightly tie into a knot.
After the sub-wire is knotted, the double hook distance has been fixed, and it is not necessary to adjust the double hook distance. When connecting, the sub-wire can directly pass through the splayed ring. The sub-wire can pass through the figure-eight ring for 4-5 cm, and then the sub-wire passing through the figure-eight ring will be wound around the non-perforated sub-wire for 2-3 times to pass through the formed circle. After the sub-thread passes through, hold one end of the knot with your hand, and gently pull one end of the double hook with your other hand to slowly tighten the sub-thread. When tightening, be careful not to hurt the secondary line.
Single-wire connection of the eight-character ring: thread the end of the sub-wire without hook out of the eight-character ring, and make 2 ~ 3 imaginary circles on the eight-character ring (the sub-wire will pass through these imaginary circles in the subsequent operation). The sub-line passing through the eight-character ring is wound 2-3 times on the sub-line not passing through the eight-character ring, and then the sub-line passes through the imaginary circle formed by the sub-line and the eight-character ring. Hold the sub-wire through the imaginary circle with one hand, gently pull one end of the hook with the other hand, and slowly tighten the sub-wire, taking care not to hurt the sub-wire when tightening.