Lu Ya tied a false bait with iron wire to tie a slipknot before fishing.

There are many ways to tie a knot in reed bud fishing. This time, the looping method of connecting Luya fishing bait with front wire is introduced. This method can ensure that the knot will not affect the underwater posture of the bait without using Luya needle.

0 1 In order to see the details clearly, and for the convenience of demonstration, alternate lines are used, such as tying knots on the lines as shown in the figure.

Then pass the knotted front lead through the connecting ring of the dummy target, as shown in the figure.

Then we put the fishing line through the hole just knotted, as shown in the picture.

Then, we fold the passing front lead in half and wind the two fishing lines together, so that the two fishing lines can wind each other 5-6 times, as shown in the figure.

Then we can pass the fake bait on the wire through the coil, but this time for demonstration, we won't pass the bait, and then pass the wire that the bait just passed through the coil through the hole, as shown in the figure.

After the thread passes through the knot, tighten the knot and continue to tie the tail knot in two directions after the knot. This is the first picture in the picture. It should be noted that the knot should be very tight.

Tie the first knot, then tie the second. The direction of the knot should be reversed to ensure that the end of the thread will not be pulled apart.

After all the knots are tied and tightened, cut off the remaining thread on it, and it's finished.