1. Should the newly bought float be scrubbed repeatedly to remove the odor?
There's no need!
Even if the fish float smells of paint, it can't be removed by washing. Only by drying and volatilizing for a certain time can it be removed naturally.
Second, to strengthen the water-breaking ability of the fish float, should the "film" on the fish float be washed off?
Some fishermen think that this can increase the hydrophilicity of the float, reduce the motion retardation caused by the surface tension of water, and thus improve the sensitivity of the float.
Actually, it will damage the waterproof paint film on the floating body and shorten the service life.
3. Is it necessary to wax the float in order to improve its ride comfort and motion sensitivity?
Sensitivity is adjusted by the fisherman. Smoothness can be maintained as long as it is scrubbed with a soft wet towel. There is really no need to wax the float.
4. When the floating tip is accidentally damaged and bent (but not broken) and needs to be corrected, can it be baked with fire?
The cup should be filled with boiling water, and the curved floating tip should be heated by its rising hot steam, and then slightly corrected by external force.
Finally, insert the upper and lower ends of the float into the screen window at the same time, so that the bent part of the float tip will continue to be slightly stressed, and it can be corrected after one or two hours.
5. In order to reduce the water absorption of floats, do you need to soak floats in water for a long time before the competition?
Some floats will leak water due to quality reasons, which will change the eye adjustment. If there is really no float to replace, you can also use this method, but it is best to replace a high-quality float immediately.
note:
When cleaning the fishing tackle after fishing, you should get into the good habit of wiping the float with a wet towel, and thoroughly clean the dirt on the float body and the float tip.
This can keep the float smooth and make the tip of the float bright and eye-catching, thus prolonging the service life of the float.
First, don't put the float in an environment with too high temperature.
Floating objects should be stored away from heating, electric heating and other heat sources as far as possible, and floating objects should be placed in a relatively low indoor temperature.
Second, keep the humidity of the surrounding environment.
In fact, the requirement of floating on environmental humidity is not too high, about 25% is completely ok. However, if the indoor humidity is lower than this value, we should try to increase the humidity (for example, using an air humidifier), or wrap the floating feet with lead skin and throw them into the water (don't let the floating body lie on the water surface, which will cause uneven soaking of the floating body), so that the water can not reach the floating tail, and then take it out after soaking for 24 hours. If you use this method, you should do it at least twice a month.
Third, the arrangement of floats on weekdays.
Try to use a standard float special box to store floats (it is best not to use a cylindrical float tube, which will make floats rub against each other and damage the paint surface of floats). Keep the float upright during storage and avoid placing it horizontally, because it is very easy to bend when placed horizontally. In addition, it should be noted that the pressure floating plate in the ballot box should not be pressed too tightly, otherwise the floating ball may be bent.
Fourthly, the floating body is reset.
For the floating objects that have been bent, you can soak them in water and then press them with heavy objects, and the general situation can be restored.
Fishing to catch more fish, in addition to fishing skills, fishing tackle can not be sloppy. Take good care of fishing gear in winter!