According to relevant legal provisions, beating each other is considered beating another person.
Legal Analysis
If the flow rate is far lower than the minimum flow rate to ensure accuracy, it will result in no output (such as a vortex flowmeter) or the output signal will be cut off as a small signal. (such as differential pressure flowmeter), this is unfavorable to the supplier and unfair. In order to prevent the loss of benefits, for a specific set of heat energy metering equipment, the supply and demand parties often agree on a certain flow value as the "agreed lower limit flow" based on the flow measurement range and the reachable range, and agree that if the actual flow is less than the agreed value , charged according to the lower limit of charging traffic. The metrological administrative departments of the people's governments at or above the county level may set up metrological verification institutions as needed, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the calibration and testing tasks specified in the preceding paragraph must pass the assessment. This function is usually implemented in flow display instruments. The metrological administrative department of the local people's government at or above the county level shall establish public measuring standard instruments based on the needs of the region, and they shall be used after passing the assessment conducted by the metrological administrative department of the people's government at the higher level. Enterprises and public institutions may, according to their needs, establish measurement standard instruments for their own use. Their highest measurement standard instruments shall be used after passing the assessment conducted by the measurement administrative department of the relevant people's government. Metrological verification work should be carried out locally and nearby in accordance with the principle of economic and reasonableness. Metrology verification must be carried out in accordance with the National Metrology Verification System Table. The National Metrology Verification System Table is formulated by the metrological administrative department of the State Council.
Legal Basis
Article 43 of the "Public Security Administration Punishment Law of the People's Republic of China" Detention for not more than five days and a fine of not less than RMB 200 but not more than RMB 500; if the circumstances are relatively minor, the offender shall be detained for not more than five days or fined not more than RMB 500. Anyone who commits any of the following circumstances shall be detained for not less than 10 days but not more than 15 days, and shall be fined not less than 500 yuan but not more than 1,000 yuan: (1) Beating and injuring others in groups; (2) Beating and injuring disabled persons, pregnant women, A person under the age of fourteen or a person over the age of sixty; (3) Beating or injuring others multiple times or beating or injuring multiple people at once