The structure of the machine is to adjust the angle of the straight wire die by rotating the high-speed rotor, so as to achieve the straightening effect. Then, when the wire reaches the required size, when the wire touches the positioning key, push the slide forward by 5mm, and the upper punch immediately presses the vertical knife to cut it off. The steel wire presses the bearing through the pressure plate on the end milling cutter, and the steel wire automatically falls on the bracket. If you want to change the length, please move the tab.
Extended data:
The motor drives the speed increase through the belt, so that the straightening cylinder rotates at a high speed, straightens the steel bar passing through the straightening cylinder, and removes the rust on the surface of the steel bar through the straightening die.
On the one hand, the motor drives two transmission rollers to pull the steel bar forward through another pair of deceleration belts and gear reducers, on the other hand, it drives the crank wheel to move the hammer head up and down.
When the steel bar is adjusted to a predetermined length, the hammer hammers the tool holder to cut the steel bar. When the cut steel bar falls into the receiving frame, the tool rest returns to its original position due to the action of the spring, completing a cycle.
Functions and features:
1, there is no error in cutting the length of reinforcement.
2. Double-head traction type.
3. Pull out the last meter of rebar after adjustment.
4. The steel wire for construction adopts tungsten steel mould.
5. The production line adopts ball-end mould, and the delivered steel bars will not damage the surface.
References:
Baidu encyclopedia-steel bar straightening machine