The operation method is as follows:
1. Plug in the power cord and turn on the red power switch. 2. Select "Prepare"-"Autohome" from the main menu to reset the platform. 3. Take out the accessories located under the platform. 4. Thread the material conduit to the eight-shaped ring of the bobbin, install the material conduit on the feeder on the back of the machine, and install the other end on the nozzle. 5. Place the glass plate on the platform and secure the glass plate with a binder clip. 6. Install the hanging piece on the back of the machine and tighten the fixing screws to fix the hanging piece. 7. Turn on the power of the printer, enter the menu, select heating, and after heating is completed, select feed 500mm. 8. When the material is about to reach the nozzle, select the "load20mm" command to extrude the material. 9. When the nozzle spins silk evenly, insert the SD card, select "printfromsd" and select the file to be printed, and the platform starts to rise.