1, align four 50cm 6-ply yarns and tie a slipknot at 20cm.
2. Make a four-strand braid with four long lines, and the length of the four-strand braid is the circumference of your finger.
3. Cut the two wires short, then press them tightly with a lighter, and then trim the knot with scissors so that they can pass through the 3mm bead hole.
4. When the slipknot at the other end is open, cut two lines like this, and then trim the knot.
5. Four wires are inserted into a 3mm 14k gold-plated bead.
6. Tighten the thread end and pull the knots on both sides into the bead hole.
7. Look to the left. With four strands as the interlayer. These two threads are tied in a diamond knot on four strands. It is enough to make a diamond knot of about 5 mm, and don't tighten the last lap yet.
8. Tie a diamond knot of the same length on the right in the same way. Make sure that the diamond knots on both sides are the same length, and then you can tighten the last turn. Then cut off the extra thread and burn it, and the ring is finished.