1. In the fishing waters that day, mix the bait first, and then start to drift.
2. The empty hook is half full. First slowly cut off the lead skin until the floating tip is half an eye or level above the water. ?
3. Then, hang a bait on any double hook and throw it into the fishing area. At this point, you will find that the float is sinking.
4. Then trim the lead skin and hang a bait. ?
5, so repeatedly, trim the lead skin until it is measured that a bait is hovering in a semi-water state and the floating tip is horizontal above the water surface. ?
6, but remember, the size of the bait you use should be estimated whether it is at the bottom of the water, because the bait will definitely melt in the process of sinking from the water surface to the bottom of the pool, and an ordinary bait will only dissolve about 2/3 from the water surface to the bottom of the pool.
7. After drifting, just take out a small ball bait to be used, and friction makes it difficult to atomize. It is an important link to adjust the drift with about 2/3 of the normal bait, and it must be just right, because the size of this bait determines the number of eyes adjusted today.