1. Materials: several meters of Chinese knotting thread (sapphire blue, cream yellow) in sizes 9-11 in two colors, lighter, scissors, tweezers.
Two. Process steps: 1. First, use a ruler to measure the length of one week of the wrist as a reference value for the finished product. 2. Start with two strands of thread (blue). First tie a figure-eight knot on each strand, then leave a certain length and join them together (about 8-12 cm). Add two more strands and fold them in half. It becomes six lines, take out one and fold it in half to form two lines and start to tie 3-4 beans (the number can be customized). Next, braid the main part. The main part is made of yellow thread in a bow shape and blue thread is knotted (the yellow ones are letters). Through the process of adding lines just now, we can see that there are six blue lines, one yellow line, and this bracelet has seven lines (you can add more blue lines to make the finished product wider). The main method here is to tell you how to tie the letters. The blue line is knotted towards the yellow line, but when it encounters a letter, the opposite is true. The blue line does not move and the yellow line is knotted. Next, follow this method of changing threads and knit until the letter is completed and reaches the length you need. Start to take up the thread. The way to take up the thread is to leave four threads and then cut off the remaining three threads. It is required to leave 0.2 cm. Use a lighter to burn the remaining parts, and then make and close the knot according to the initial operation (flat knot - figure eight knot). 3. To knit the knot-adjusting buckle, cross the remaining four lines together, and start to tie a flat knot at the intersection point (the method is the same as before), with a length of about 3-4 cm.
Three. Finishing and styling: Whether the finished product is in place and finishing is very important. First, check whether the thread ends are firmly bonded. Next, check whether the lettering is deformed, whether the front surface has a three-dimensional feel, and whether the joints are exposed from the front. These all need to be processed.
Key tips:
1. The thread is easily deformed after being exposed to water, so try not to wash it with water.
2. The letters are knitted by changing threads, so the hand feel must be consistent during the knitting process. Evenly.
3. In order to achieve the best appearance, it is required that the joint or burned part must be processed on the opposite side.
4. Because I have just started knitting, the amount of thread used is not accurate, and the joints are troublesome, so I need to leave some extra thread.
5. If you don’t know how to make a figure eight knot yet, you can use 4 beaded ribbons to replace it without affecting the effect.
56 Taobao Mall (56tmall,.com)