The dumping of C1 requires the dumping of two garages next to each other. There is a moving process in the middle, which involves many "points" and corresponding directional movements. This is the point position in learning to drive. It is also the most complicated to do more. I will tell you the overall steps of the standard examination process:
1. First, park the car in front of the right parking lot;
2. From the right parking lot Overturn the right front gear and pour it into the left warehouse. This is referred to as "first inversion". The standard is that the rear of the car is about 10cm from the rear edge line (generally the training ground and examination room have a "shoulder line" as a reference);
3 . Start the "moving library" action from the left library, that is, move from the left library to the right library. It can only be done in the space surrounded by 6 benchmark poles. You cannot bump the poles in the middle, except for pressing the line in the middle of the two warehouses. No other lines can be pressed on the outside; the standard is that the four wheels have completely entered the right warehouse. At this time, no lines must be pressed or the poles must be hit;
4. Start from the right warehouse and go out through the left warehouse door. Drive to the left front of the garage and stop upright;
5. Then shift into reverse gear and pour into the right garage. This is referred to as "second reverse". The standard is to pass if the front of the car enters the right garage by more than 20cm;
6. Exit the right warehouse and drive to the right front of the right warehouse. Just reach the place where you first got on the bus and stop.
Note: Do not hit the pole or press the line during the entire process, otherwise points will be deducted
The skills are:
1. Drive as slowly as possible , if you are slow, you will generally not misplace the "point position", and you will have enough time to set the direction and correct the direction;
2. Follow the order of "first fall, move to the library, and second fall" to move the "point positions" taught by the coach "Remember it. If necessary, write it down on paper and read it again. Be sure to remember the position and order;
3. The speed of the vehicle and the direction of driving must be well coordinated. When driving in the reverse pile, you can drive faster. Give yourself more time to look at the "points".
4. The other thing is to have a good attitude and don’t be nervous.
Direction modification suggestions: You can modify the direction after your car's rearview mirror enters the garage. The principle is to turn the direction from which side is wider. When the distance is suitable, remember to turn the steering wheel back in the opposite direction. Measure the range, and then return to the straight line. At this time, the car will probably be on the middle lane of the garage until it stops behind the "shoulder line".