The bracelet weaving methods are as follows:
Weaving method one:
We first take out a colored thread, cross it, make a small circle at one end, and then One of the single lines goes in a figure-eight shape around the part where they intersect. When it is almost the same length, we tighten the other end for adjustment. Then repeat the above steps. Finally, just connect the two ends together.
Wedding method two:
We take two colored lines and divide them into line a and line b. We wrap line a around line b to form a circle, and line b goes out of the circle in a counterclockwise direction. After tightening them, we can just repeat the above steps. Finally connect the two ends together.
Braiding method three:
We first prepare a black colored rope, fold it in half, and then put a slip knot on it. There is no need to fold it in half from the middle. Next, we take another black colored rope, wrap it around the main body for a while and fix it. Then we take a white rope and wrap it around the main body for a while and fix it. We alternated black and white colored ropes.
Finally just connect the two ends together.
How to tie the necklace lanyard:
1. Four-ear knot, take the rope out of the top, bottom, left, and right ears, and then tie the knots in sequence.
2. Fold the knot in half, first fold the thread in half, then thread it into the necklace pendant and tie it, and then adjust the necklace.
3. For the Diamond Knot, fold the rope in half, press the left rope on the right rope, and then wrap the left rope around the right rope, leaving a loop to tighten.