Preparation tools/materials: fishing line, hook and splayed ring.
1. First, tie the strap on the sub-wire, and then thread it into the splay ring. As shown in the figure.
2. Then tie a horseshoe knot at the thread end, and the two coils are arranged neatly. As shown in the figure.
3. Then thread the double hook into the horseshoe knot, and then tighten the sub-wire. As shown in the figure.
4. Finally, thread one of the hooks into the thread end of the bottom thread and tighten it. As shown in the figure.
Hook, a tool used to hang bait to attract fish when fishing. At present, the development of fish hooks is very fast, and there are many kinds, including stainless steel and carbon alloy steel, and there are many sizes and models.
The hook consists of six parts: handle, handle, hook bend, hook tip, hook door and hook bottom. Each part has its specific function and is an essential tool for fishing. A perfect fishing tackle combination is a sharp weapon to help you become a master fisherman, and the hook is a key link.
Pre-junction circulation method
1, along the hook handle, wind the fishing line around the hook handle, with the small hook winding 4 times and the big hook winding 6 times, leaving a thread end of about 4 cm at the bottom of the hook.
2. Close to the fishing line at the handle of the hook, make an opposite coil and insert it from the hook tip. In this way, when passing through the two coils, be sure to press the thread end on the bottom of the hook.
3. Pull the line at the bottom of the hook with pliers, pull the fishing line at the handle of the hook by hand, and tighten it hard to cut off the redundant line at the bottom of the hook. The other hook does the same, and the two hooks are tied together.
Please click to enter a picture description.