The most common figure-eight ring (figure-eight ring) connector with two closed ends is named by the number 8. It has simple structure and convenient operation, and can rotate as fast as rings at both ends. In the process of fishing, it can effectively avoid the distortion and damage of the line group, resulting in fish running. The disadvantage is that it is troublesome to replace the sub-wire, and it takes a little time to cut the atomic wire and tie the new sub-wire.
The function of the open octagonal ring is the same as that of the closed octagonal ring, but the difference is that it needs to be used in conjunction with the O-ring, as shown in the following figure.
The advantage of opening the splayed ring is that it is more convenient to replace the secondary line, because the secondary line has already tied the O-ring in advance. When replacing, just take off the original O-ring and hang a new one inside. Moreover, the elasticity of the O-ring shares the pressure of some line groups and fishing rods, which is more suitable for fishing big fish. In order to avoid deformation, the opening part is thick, while the closing part is normal in size.
Advanced products of ordinary eight-character ring, double high-speed eight-character ring, alas, the manufacturers don't blow well, and all kinds are good. In fact, Bian Xiao himself doesn't like it very much. First I gained weight, and then I used it several times. I don't feel the advantage. On the contrary, sometimes the sub-line will be sandwiched between two cylinders, so the back is not used.
Quick clip, the effect is similar to the opening eight-character ring, eliminating the O-ring, which is very convenient when fishing small fish. The sub-clamp is knotted in advance. When replacing it, hang the hook and pull down the rubber sleeve, as shown in the figure below.
The above kinds are commonly used in the process of Taiwan fishing, and each has its own advantages. New fishermen can choose according to their own preferences and habits, and they can all have a good experience.
Finally, I have seen many novice friends use this pin connector when fishing. Some are used to connect the main line and the pole, and some are used to connect the main line and the auxiliary line. It looks convenient. Just fasten the pin, but it's actually wrong. This connector is very unsuitable for polar group. Firstly, the distance between the second pin and the splay ring is too large, which affects the sensitivity of the wire group, and then it is easy to wind the wire group.