There are many pendants that need to be woven with rope, and red rope is one of them. Red rope can bring good luck to everyone, which is very fashionable. It would be fun if you could knit one yourself. Let's study together!
Tools/raw materials:
You can hang several red ropes, which is a multiple of 3.
Scissors lighter
Methods/steps:
1. Burn both ends of the rope into filaments with a lighter, bake the rope with a torch, pinch it while it is hot, and let the rope pass through the hole.
2. Pass two charred ropes through the pendant hole together.
3. Leave an appropriate binding length according to personal preference, such as 1cm.
4. Untie the rope. At the end of 1cm, open the end of the rope and tie a knot on the other side.
5, repeat the fourth action, and then go around to the other side to tie the knot, be sure to tie it tightly.
6, then reverse the knot, one positive and one negative alternate knot.
7. Tie the knots one by one until the length of the rope ends remains, and the remaining 1cm will not be completely filled.
8, with a lighter at the end. Burn the port with a lighter. Be sure to press it firmly and don't let the wires fall off.
Precautions:
Note that the length of the rope must be long enough for weaving, otherwise it will not knot.
Do you have to burn it with a lighter, or it will fall off.
Illustration of rope weaving of pendant necklace
Boutique Red Rope Bracelet The knitting diagram of the boutique red rope bracelet here will tell you how to weave the boutique red rope bracelet.
The first step of weaving fine red rope bracelet: material preparation 25th embroidery thread, 6 treaty preparation 1 meter long embroidery thread. The first step of the bracelet: choose your favorite color, arrange the red ropes, and glue them with transparent glue so that one end can't move. Fine red rope bracelet weaving Step 2: Place the A line on the B line, and the first step of bracelet weaving begins. Line a turns around line b from top to bottom. Fine red rope bracelet weaving Step 3: Tighten the A and B lines.
The fourth step of the red rope bracelet weaving method: A repeatedly winds the B line 1 turn, and then tightens the second turn. Step 5: Next, the A line is wound around the C line twice, and then the two red bracelets are tightened. Step 6: Line A circulates with Line D, Line E and Line F respectively in the same order. Step 7: Next, Line B circulates with Line C, Line D, Line E, Line F and Line A twice/Step 8: Boutique red bracelet.
Cut off the extra thread at the end. The threads at both ends can be braided with three braids, and soon a beautiful lucky red rope will be made.
How to weave a necklace with red rope
There seems to be one online. I have seen it once, but I don't know how to find it.
I've done this before and learned it. I don't know.
Simply put, if you fold a red rope in half, you can twist it all the time and tie a few splayed knots after twisting it for a while. The figure-of-eight knot is to put both sides of the rope flat on the left hand, hold it down with the thumb and forefinger of the left hand, then pick up the rope with the right hand and put it outside, then pick up the rope outside and bypass the rope placed on it, go in from below (a hole will be formed in the middle), and pull the rope out and flatten it to form a figure-of-eight knot.
In the meantime, keep your left hand pressed and don't let go. You can try it first.
Twisting rope is also the part where the left hand holds the folded part and the two ends are connected together, and then the right hand holds two ropes and twists them in one direction. Don't separate your hands too far, about three centimeters. After two or three twists, the left hand moves to the right hand position, and the right hand moves down three centimeters and then twists.