Huatai Santa Fe 1.8T camshaft only needs to be installed at the non-TDC position of the crankshaft, because the camshaft will let the valve go down. If the crankshaft is in the top dead center position, a collision accident will occur, resulting in valve damage. Tighten the screws gradually from the middle to both sides. The specific operation steps of camshaft timing and crankshaft timing calibration are as follows:
1, select the crankshaft clockwise.
2. Let the top dead center tool reach the highest position.
3. At this time, the crankshaft timing points are aligned.
4. The camshaft balance line is aligned with the protruding position of the cylinder block.
5. Use a ruler to determine the horizontal alignment and complete the alignment.